single layer pcb

source Everything You Need To Find Out About Single Sided Printed Wiring Boards A Printed Circuit Board (also called Printed Circuit), which is also known as etched wiring board or Printed Wiring Board (PWB), is a board used to electrically connect electronic parts. Right away, Printed Wiring Boards find their application in an wide range […]

Read more
Direct ink to PCB CNC-Plotter pt. 2

This is part two of the CNC-Plotter videos for part one see here: Part three see here: This part shows the workflow of a PCB plotting from start to finish, with added detail to the workings of the plotter itself. Remember, the plotter is entirely made of leftover junk and some brass and CFK material […]

Read more
PCB Plotter v3 test plot

This is a test plot with the v3 plotter. The board file was kindly contributed by Vasile Guta Ciucur. Gear slack and acceleration settings are not optimal yet so some lines may be closer together than they would normally be. The arduino firmware, as well as the 3D printer files used for this are available […]

Read more
This is simplest possible board for ARM (STM32) – single layer, single sided, and only 1 capacitor

Many people think that ARM is very hard to use and require 4-6 layer PCB with lots of support circuitry. This proves that you can have it working as simple as plain old AVR – just single layer single sided board, linear regulator (3.3v), capacitors before(optional) and after(2.2-4.7uF ceramic) regulator and single resistor at BOOT0 […]

Read more
SPEED-BUSTER Chiptuning Box productiefase – Speciaal gemaakt in Duitsland

De SPEED-BUSTER® chiptuningbox word, afhankelijk van het voertuigtype, aan één of meerder sensoren van de motor aangesloten. Door de voertuigspecifieke kabelboom met originele stekkerverbindingen worden de sensor-signalen direct naar de tuningmodule gestuurd, dan door een microprocessor in real-time-data omgezet en opnieuw berekend om dan naar het motor stuurapparaat (ECU) te worden doorgegeven. Door deze herberekening […]

Read more